• Obecnie brak na stanie
OP4EB-InertialSensor
search
  • OP4EB-InertialSensor
ID: 207608

Open4 hardware extension with MEMS 3-axis gyroscope, magnetometer, pressure and temperature sensors

Wycofany
 

Wysyłka gratis

darmowa wysyłka na terenie Polski dla wszystkich zamówień powyżej 500 PLN

 

Wysyłka tego samego dnia

Jeśli Twoja wpłata zostanie zaksięgowana na naszym koncie do godz. 11:00

 

14 dni na zwrot

Każdy konsument może zwrócić zakupiony towar w ciągu 14 dni bez zbędnych pytań

Open4 Inertial Sensor is a hardware extension board designed to add additional evaluation features to the Open4 primers, EvoPrimer or STM32 Primer2 evaluation and development platforms. By adding the Intertial Sensor extension to any of these platforms, users can develop their applications using input from MEMS:

  • Magnetometer, 3 Axis accelerometer (LSM303DLH)
  • Gyroscope (L3G4200D)
  • 300-1100 mbar pressure sensor (LPS001D)

The Inertial Sensor installs on the 20-pin extension connector of the Open4 or Primer2. When installed, the board is fully contained inside the tool's protective casing.

While tool users can implement component features in a wide variety of potential applications, the combination of devices on the Inertial Sensor board were specifically selected to allow applications to detect the precise position and movement of the Open4. This includes monitoring the tool's:

  • Movement relative to magnetic north
  • Tilt, Pitch, roll and yaw
  • Elevation

Only available while supplies last.

207608

Produkty z tej samej kategorii (16)

W ramach naszej witryny stosujemy pliki cookies w celu świadczenia Państwu usług na najwyższym poziomie, w tym w sposób dostosowany do indywidualnych potrzeb. Więcej szczegółów w naszej polityce prywatności.