Micro:Mate is an expansion board for the micro: bit development module....
ual MAX14870 Motor Driver is a dual DC motor driver compatible with the...
Reflective sensor module with 16 QTRX-MD type optocouplers with analogue...
A desoldering station with a heating capacity of 80W, with a ceramic...
STSPIN220 stepper motor driver module with a low voltage range of...
10-pin Needle Adapter to connect Flasher 5, Flasher ST7 or Flasher STM8 to a PCB, Segger
10-wire ribbon cable (1.27mm to 2.54mm) for Segger J-Link EDU mini
Flash programmer for M16C, M32C, R8C, R32C, M38000 and ST9 series of flash microcontrollers, Segger
Programming tool for Renesas M16C/62, M16C/80, M32C, M79, R32C, R8C series of microcontrollers, Segger
Flash Programmer for ARM and Cortex cores, Segger
Flash Programmer for PowerPC cores, Segger
Flash Programmer for ARM7/9/11, Cortex, RX and PPC cores
Flash Programmer for Renesas RX cores, Segger
Flash programmer for ST7 series of flash microcontrollers with on-chip flash
Flash programmer for STM8 series of flash microcontrollers with on-chip flash, Segger
JTAG/SWD Emulator with USB interface for educational use, Segger
J-LINK EDU Mini is a version of the J-Link EDU (8.08.90) in a reduced form factor with identical functionality for Cortex-M based targets. It has been designed to allow students and educational facilities as well as hobbyists access to top of the line debug probe technology. Version for non-commercial use only. J-Link EDU mini
Standard 20-pin 0.1 male connector to provide electrical isolation, Segger
J-Link Needle Adapter - connect J-Link to a PCB, Segger
Hi-Speed JTAG/SWD Emulator with USB and Ethernet interface, Segger