Double operational amplifier with low power consumption in the MiniSO8...
Switching power supply LED designed to power industrial automation...
Espruino module with Bluetooth LE based on MDBT42Q system with Nordic...
Dispensing needle for precise application of glue, flux with an inner...
The ESP32 WiFi and Bluetooth module has a dual-core 32-bit MCU that...
30 cm HU04 cable
30 cm HU06 cable
An expansion board (shield) extends functionality of development board from STM32 Nucleo series. The shield has ST Morpho connectors and was equipped i.a. with 4-Digit 7-Segment LED Display, four RGB LEDs, accelerometer LIS35DE, pressure sensor LPS25HB and also digital thermometer DS18B20.
Multifunctional expander (shield) for NUCLEO and Arduino equipped with Bluetooth 2.0+EDR (HC-05) interface, MEMS 3DoF LIS35, LED-RGB, joystick and analog STLM20 temperature sensor developed and produced by KAMAMI.
A functional expander for NUCLEO and Arduino with a set of environmental sensors: pressure, humidity, temperature and light intensity and also a 5-position joystick and LED RGB.
Stereophonic 2 x 650 mW audio amplifier
Pressure sensor module with I2C interface (MPL115A2)
KAmodBT-HC05 is a Bluetooth module configured via AT commands. It has integrated LEDs indicating operating mode and connection status with the paired device, as well as a logic level translator on UART lines. KAmodBT-HC05
Module of a stereo 24-bit audio converter with I2S interface (TS4657).
8-position DIP-Switch Module
Module with SPI 8-bit I/O Port Expander
Module with I2C I/O Port Expander
KAmodHTS221 is a module, which allow to make a measurement of humidity and temperature. Thanks to an embedded voltage regulator and a logic level translator, it can be used in embedded systems with power supply 2.5...5.5V.
ISP Atmel 6-pin ISP Atmel 10-pin adapter
16-button matrix 4×4 keyboard