
MAXimator PROMO with Expander...
49.00EUR
This compact (0.4″ × 0.5″) switching...
This IR LED/phototransistor pair is great for precisely identifying...
The RoboClaw motor controllers from Ion Motion Control (formerly Orion...
The RoboClaw motor controllers from Basicmicro (formerly Ion Motion...
The Pololu Zumo 32U4 robot is a versatile tracked robot based on the...
10 DOF IMU Sensor (B), Inertial Measurement Unit, Lower Power Consumption
Inertial measurement unit (IMU) and altimeter that features the same LSM6DS33 gyro and accelerometer and LIS3MDL magnetometer as the MinIMU-9 v5, and adds an LPS25H digital barometer. Pololu 2739
Precision sensor from Bosch for measuring humidity with ±3% accuracy, barometric pressure with ±1 hPa absolute accuraccy, and temperature with ±1.0°C accuracy Adafruit 2652
Flexiforce Pressure Sensor A401 – 10lbs, Tekscan, RoHS
BME280 integrates onboard temperature sensor, humidity sensor and barometer. It provides both SPI and I2C interfaces; and can be widely used in environmental monitoring, story height measurement and Internet of Things (IoT) control and so on. SEN0236
Pressure sensor module with I2C interface (MPL115A2)
Best low-cost environmental sensing solution with BME280 and Si1132 on one board. The combination of the BME280 sensor and the Si1132 sensor enables measuring temperature, barometric pressure and humidity, UV Index and ambient light at once
MPL115A1 Barometric Pressure Sensor Breakout Board
This sensor shield utilizes the BME280 pressure/humidity/temperature sensor, the CCS811 air quality sensor and the APDS-9301 ambient light sensor - using each corresponding Arduino library. The shield has been equipped with two RJ11 connectors for wind and rain detection and measurement, as well as optional pins for external temperature readings and soil...
The SparkFun Load Sensor Combinator is a bare PCB that combines four load sensors into a standard four-wire Wheatstone bridge configuration. BOB-13878
Simple-to-use, open source solution for measuring weight and temperature with the ability to read multiple types of load cells and offers a simple-to-use serial menu to configure calibration value, sample rate, time stamp and units of precision. SEN-13261
Easy to use Arduino shield that grants you access to barometric pressure, relative humidity, luminosity, and temperature. There are also connections to optional sensors such as wind speed/direction, rain gauge, and GPS for location and super accurate timing. DEV-12081