The heart rate sensor: a thumb-sized heart rate monitor designed for...
This is a basic breakout board for the FTDI FT232RL USB to serial IC....
The Bluno Beetle Shield expands the Beetle's single analog and digital...
Beetle BLE is another milestone in wearable electronics device area...
Beetle is a extremely the smallest Arduino leonardo board with Atmel...
10-wire ribbon cable (1.27mm to 2.54mm) for Segger J-Link EDU mini
Evalutaion board with STM32RBT6 microcontroller and TFT screen
ARM Cortex-M3 STM32F103VET6 STM32 development board with 2.4 TFT touch screen
DevKit1207 Evaluation Kit including 3.5"LCD with touch panel (STM32F207IGT6)
STM32F103ZE ARM-CM3 Board
J-LINK EDU Mini is a version of the J-Link EDU (8.08.90) in a reduced form factor with identical functionality for Cortex-M based targets. It has been designed to allow students and educational facilities as well as hobbyists access to top of the line debug probe technology. Version for non-commercial use only. J-Link EDU mini
Hi-Speed JTAG/SWD Emulator with USB and Ethernet interface, Segger
Hi-Speed JTAG/SWD Emulator for ARM7/9, Cortex and Renesas RX cores with USB interface, Segger
ARM ULINKpro-D Debug and Trace Unit
Evaluation board with STM32F103VCT6 microcontroller with 3.2 inch TFT display and touchpanel
Versatile, low-cost debugger and programmer for 8-bit and 32-bit microcontrollers
J-Link 6-pin Needle Adapter (8.06.16)
JTAG/SWD Emulator for ARM7/9, Cortex and Renesas RX cores with USB interface, Segger
ST-LINK/V2 in-circuit debugger/programmer for STM8 and STM32 microcontrollers
Evaluation board with STM32F100 microcontroller