This is the FeatherWing OLED: it adds a 128x32 monochrome OLED plus 3...
This synchronous switching step-down (or buck) regulator takes an input...
This is the tiniest little LED grid, with 64 full RGB color pixels in a...
Laser dust sensor is a digital universal particle concentration...
Camera for computer Banana Pi M2+, with sensor CMOS 5 Megapixels...
16x2 LCD + IO Shield for ODROID-C1 / C0 / C2
Lithium Polymer rechargeable cell with a Protection circuit. Compatible with ODROID-C0
Mini USB Bluetooth dongle compatible with ODROID-C1, C1+, C0, C2 and XU3, XU4
What you need is an add on prototyping T-breakout board, which can break out all those tasty power, GPIO, I2C, ADC pins from the 40 pin header onto a solderless breadboard. This set will make "cobbling together" prototypes with the ODROID-C1 super easy
The HiFi Shield Plus provides both stereo RCA connectors to connect to external amplifiers and other audio equipment. Via TI's high-end PCM5242 DAC chip (Burr-Brown), it supports 16, 24, 32 bit audio formats with minimal THD+N ratio 0.002% and ideal dynamics 114dB+ plus amazing sampling rates of 384kHz
Works with the ODROID-C2 / C0 / C1+. The HiFi Shield provides both stereo RCA connectors and a 3.5mm stereo jack (all gold-plated) to connect to external amplifiers and other audio equipment
The HiFi Shield Plus provides both stereo RCA connectors and a 3.5mm stereo jack (all gold-plated) to connect to external amplifiers and other audio equipment. Via TI's high-end PCM5102 DAC chip (Burr-Brown) it supports 16, 24, 32 bit audio formats with minimal distortion -93dB and ideal dynamics 110dB+ plus amazing sampling rates of 384kHz
LED Matrix Shield works with ODROID-C1 / C1+ / XU4 (combination with XU4 Shifter Shield)
Attitude Heading Reference System, Odroid C0, C1, C1+, C2, XU3, XU4
A new game controller that is similar to the steering wheel available for the Nintendo Wii. It is built using the USB IO BOARD and an auxiliary motion sensor, and allows you to play many games available for mobile phone that would normally use the phone’s gyroscope
Odroid UPS2 for C1/C1+/C2
USB IO Board, compatible for ODROID-C2, C1, C1+, C0, XU4 Series
USB-UART board for ODROID, Compatible with ODROID-C1, C1+, C0, XU4, C2
Best low-cost environmental sensing solution with BME280 and Si1132 on one board. The combination of the BME280 sensor and the Si1132 sensor enables measuring temperature, barometric pressure and humidity, UV Index and ambient light at once
The ODROID-UPS3 (Uninterrupted Power Supply) device is designed specifically for the ODROID-C1,C1+ and ODROID-C2. It is equipped with a rechargeable Lithium-Polymer Battery, Charger IC and 5Volt Boost DCDC