Precision sensor from Bosch for measuring humidity with ±3% accuracy, barometric pressure with ±1 hPa absolute accuraccy, and temperature with ±1.0°C accuracy Adafruit 2652
BME280 integrates onboard temperature sensor, humidity sensor and barometer. It provides both SPI and I2C interfaces; and can be widely used in environmental monitoring, story height measurement and Internet of Things (IoT) control and so on. SEN0236
Ideal for environmental sensing and data logging and perfect for build a weather stations or humidor control system; built-in 4.7KΩ pullup resistors for I2C communications. SEN-13763
Best low-cost environmental sensing solution with BME280 and Si1132 on one board. The combination of the BME280 sensor and the Si1132 sensor enables measuring temperature, barometric pressure and humidity, UV Index and ambient light at once
HIH-4030 Humidity Sensor Carrier
This sensor shield utilizes the BME280 pressure/humidity/temperature sensor, the CCS811 air quality sensor and the APDS-9301 ambient light sensor - using each corresponding Arduino library. The shield has been equipped with two RJ11 connectors for wind and rain detection and measurement, as well as optional pins for external temperature readings and soil...
Simple breakout for measuring the moisture in soil and similar materials. SEN-13637
Easy to use Arduino shield that grants you access to barometric pressure, relative humidity, luminosity, and temperature. There are also connections to optional sensors such as wind speed/direction, rain gauge, and GPS for location and super accurate timing. DEV-12081
A fully loaded “carrier” board for the micro:bit
Soil moisture sensor based on soil resistivity meansurement
The set contains: MQ-5 Gas Sensor, Color Sensor, Flame Sensor, Hall Sensor, Infrared Reflective Sensor, Laser Sensor, Moisture Sensor, Rotation Sensor, Sound Sensor, Temperature-Humidity Sensor, Tilt Sensor, UV Sensor, Liquid Level Sensor. Modules compatible with Arduino
Motion MEMS and environmental sensor expansion board for STM32 Nucleo, equipped with Arduino UNO R3 connector layout; designed around the LSM6DSL 3D accelerometer and 3D gyroscope, the LSM303AGR 3D accelerometer and 3D magnetometer, the HTS221 humidity and temperature sensor and the LPS22HB pressure sensor. The board interfaces with the STM32...